Manuals

Back to Contents Page

Dell™ OptiPlex™ GX520 User's Guide

  I/O Panel

I/O Panel

Removing the I/O Panel

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

NOTE: Note the routing of all cables before disconnecting them, so that you can re route them correctly when installing the new I/O panel.

1. Follow the procedures in "Before You Begin."
   
   
2. Remove the cable from the I/O panel by pulling on the pull-loop.
   
   
3. Remove the screw that secures the I/O panel to the desktop computer.
   
   

NOTICE: When sliding the I/O panel out of the computer, be extremely careful. Carelessness may result in damage to the cable connectors and the cable routing clips.

4. Gently rotate and slide the I/O panel away from the computer.
   
   

1	securing screw
2	I/O panel
3	I/O cable connector
4	I/O connector pull-loop

Replacing the I/O Panel

1. To replace the I/O panel, follow the removal procedures in the reverse order.
   
   

NOTE: Use the guides on the I/O panel bracket to help position the I/O panel in place and use the notch on the I/O panel bracket to help seat the card.

Back to Contents Page